GM-Trucks.com. This is a guide I found on NGK's website: 1. Installing Spark Plugs Torque is one of the most critical aspects of spark plug installation. Installation Without a Torque Wrench: In most engines, replacement plugs can be installed without using a torque wrench but extra care should be taken to ensure the.

Change your spark plugs yourself to maintain peak performance and high gas mileage. In most cases it's a simple job as long as you have the right tools.

How to Replace the Spark Plugs on a Silverado/Sierra : How- To Articles. First thing you want to do is buy the appropriate plugs and wires for your truck. Check what the gap is and set it on all the plugs prior to so you don't have the . Next locate where all your plugs are, on the V8 6. L they are all on the sides and easy to locate.

Time: 2 hours for the first time plug replacer without all proper tools and a kid going through your toolbox. Tools required: Ratchet. Torque wrench. Universal Joint. Various extensions(6in worked for all but one)(.. L)Spark Plug Socket(5/8ths in my case)Spark plug boot pullers(or slip joint pliers)Spark plug gap tool(if not pregapped to your truck)Toothbrush. Next figure out what side of the engine you are going to work on.

I chose the right side and it was very simple. First off pull the upper part of the wire from the engine. This should be very easy, never pull a spark plug wire by the wire itself, it will break and make your life much harder; pull it by the rubber boot. Make sure you only pull one wire at a time, not so confusing for vehicles without distributor caps but still it maintains order. Once you have the upper portion pulled next you will remove the wire from the plug. If you have a boot puller, attach it and give it a twist and pull and it should all come out very easy. If you only have a pair of slip joints grab it by the boot and twist it a few times.

The boot will probably give you quite a bit of trouble but keep going till it is off. If the wire comes off don't fear. Just keep working on the boot. Occasionally the boot will come off and leave the electrical connector on the top of the plug, gently pull it straight off the top of the plug at the same angle of the plug.

Supplies required: Spark plugs. Wires. Spark plug and boot gel(from auto store for real cheap)Once the wire is off, remove the spark plug using your ratchet and spark plug socket. Once it is off inspect the spark plug at the bottom. Download Mp3 Gratis Ost Macgyver Episode.

Most auto guides will give you a chart to inspect by. You can see if there is unhappy things going on in your engine by spark plug inspection. Here is a photo of how to read your spark plugs: Toss the old plug away so you don't mistake it and put it back in.

Take your gapped new spark plug and coat the threads with plug gel; make sure to keep it away from the last two threads. Battlefield Bad Company 2 Multiplayer Crack Pc Download. Now carefully by hand place it back in the engine and turn it by hand as much as you can. Now turn it with the torque wrench or ratchet if you don't have it, either to recommended tq or nice and tight, be careful not to over tighten and bust threads or break the plug. Now add the wire gel to your new ones and connect the upper and lower boots. You should hear a slight click on the spark plug. With the right tools this is not a problem.

The top of my craftsman plug socket has a 3/4 threading for a short extension to be made by turning it with a 3/4 socket instead of straight on.